Part number SP1571
2012-15 Honda Civic
1.8L 4cyl. (9th gen)
1- 2 pc. cold air intake
equipped
with
MR Tech and Air Fusion
1-
3” webb/nano fiber dry filter
(#1020)
1-
2.50x2.75” step hose
(#3116)
1-
3”
straight hose (#3044)
2- Power Bands
#040
(#4003)
2- Power Bands
#048
(#4004)
2- M6 vibra-mount (#6020)
2- M6 flange nuts (#6002)
2- Fender washer (#6010)
1- Vinyl 1/4” coupler (#8008)
1- Vinyl Trim @6”Long (#6023)
1- 15mm [email protected]”Long(#3079)
1- 4 page instruction
Note: All parts and accessories now
sold on-line at :
“injenonline.com”
Note: The C.A.R.B. Exempt sticker must
be attached under the hood in a manner
that is easily viewed by an emissions
inspector.
CARB E.O. 2012-2013 Models Only
Congratulations! You have just purchased the best engineered, dyno-
proven cold air intake system available.
Please check the contents of this box immediately.
Report any defective or missing parts to the Authorized Injen
Technology dealer you purchased this product from.
Before installing any parts of this system, please read the instructions
thoroughly. If you have any questions regarding installation please
contact the dealer you purchased this product from.
Installation DOES require some mechanical skills. A qualified
mechanic is always recommended.
*Do not attempt to install the intake system while the engine is hot.
The installation may require removal of radiator fluid line that may be
hot.
Injen Technology offers a limited lifetime warranty to the original pur-
chaser against defects in materials and workmanship. Warranty
claims must be handled through the dealer from which the item was
purchased.
Injen Technology 244 Pioneer Place Pomona, CA 91768 USA
Please check the contents of this box immediately.
Note: This intake system was Dyno-tested with an Injen filter and
Injen parts. The use of any other filter or part will void the
warranty and CARB exemption number.
Parts and accessories are available on line at “Injenonline.com
Note: Injen strongly recommends that this system be installed by a profes-
sional mechanic.
Figure 1
Figure 2
Warning: Manufactures attempting to duplicate Injen’s
patented process will now face legal action.
MR Technology Step down process:
1- Calibration Method for Air Intake Tracts for Internal Combustion Engines.
Covered under Patent# 7,359,795
2- Calibration Device for Air Intake Tracts for Internal Combustion Engines.
Published and patent pending
3- Calibration Method and Device for Air Intake Tracts having Air Fusion Inserts
Published and patent pending
Cyborg Intake System
“The World’s First Tuned air Intake System!”
Factory safe air/fuel ratio’s for Optimum performance
Injens tuning process covered by three U.S. Patents
