Promi SD™ User Manual ver 1.7
www.initium.co.kr
54
result to Host. To lease periodic
inquiry function, AT+BTCANCEL.
28)
AT&V
Shows S-register values
S-register command: If you change the values of S-register, please reboot Promi SD.
ATSnn=mm<cr>: To change ATSnn register value
ATSnn?: To check current ATSnn register value.
29)
ATS3
Stream UART policy (Default 0)
If set as ‘0’, throughput is the priority, if set as ‘1’, Latency
is the priority.
30)
ATS4
Enable Remote name query (default 1)
Get BDaddress and device name during Inquiry.
If set as ‘0’, only get BD address. Inquiry time can be
faster.
31)
ATS10 Default
1
ATS10=1<cr> :
Enabling all of the response messages- OK, CONNECT,
DISCONNECT, and ERROR.
ATS10=0<cr> :
Disabling all of the response messages- OK, CONNECT,
DISCONNECT, and ERROR.
ATS10?<cr> : To see current status of ATS10
32)
ATS11
Enable Escape (default 1)
Escape sequence character enable change from on-line
mode to command mode. If set to ‘0’, transmission speed
can be improved.
33)
ATS12
Clear UART buffer at Disconnect. (default 0)
If set to ‘1’, when disconnected, data stored in Promi SD
will be removed.
34)
ATS13
Enable CDC accept (default 0)
If set to ‘0’, Promi SD will use CDC signal to let Host know
Bluetooth connection status.
