18
F# E# or F## E## code
other than as described
above appears in display
System error code.
Touch POWER once to clear the code. Then touch POWER
again and restart the washer. If code appears again, call for
service. Unplug washer for 30 seconds; then plug back in.
Washer making error
beeps
Door has not been opened and
closed for at least three cycles.
This code may occur when the washer is first turned on.
Open and close the door to clear the display.
Washer beeps when Start/
Pause is touched
Door not closed.
Close the door completely.
CL appears on display,
or Clean Washer LED
flashing at end of wash
cycle (on some models)
The washer has run 30 wash cycles
and is indicating a reminder to run the
Clean Washer cycle.
Run the Clean Washer cycle. If the Clean Washer cycle is not
turned on, the LED will stop flashing at the end of a wash cycle
after running three more regular wash cycles. After 30 more
wash cycles are completed, the Clean Washer LED will again
flash at the end of a wash cycle as a reminder.
Washer won’t start
Control lock could be enabled.
To check whether the unit is in control lock, try powering On
the unit. On doing that if you see the code ‘Loc’ displayed
in the seven segment display, then you know that control
is locked. To unlock controls press and hold the CONTROL
LOCK key for 3 seconds.
Be sure the door is closed.
Make sure you press and hold the start button for 1 full second.
Make sure the door has been opened and closed since the last
cycle was run.
“PF”
Appears upon recovery from power
loss, if power was lost while running
a cycle.
Touch POWER once to clear the code. Then touch POWER
again and restart the washer.
F0 E5 or “ob”
Off balance load detected. This
means that your washer detected an
off balance load and that caused the
cycle to take longer than usual or the
clothes to be more wet than usual.
Touch POWER once to clear the code. Then touch POWER
again and restart the washer.
“dr” or F5 E4
Door not opened between cycles.
Open and close the door. Touch POWER once to clear the
code. Then touch POWER again and restart the washer.
TROUBLESHOOTING
If you experience
Possible Causes
Solution
Error Code Appears in Display (for 2- and 3-digit displays) (cont.)
“rL” (remove load) appears
in display
Load detected in drum during Clean
Washer cycle.
Remove items from washer drum and restart Clean Washer
cycle.
Loc
Control is locked.
This is not an error code but just an indication that the control
is locked. Press and hold the control lock key for 3 seconds to
unlock.
First try the solutions suggested here or visit our website at
www.inglis.ca
for assistance and to possibly avoid a service call.
