3
GRINDER SPECIFIC WARNINGS
•
Always match collet size with accessory shank size.
•
Always insert tool shank no less than 10 mm in the
collet. Tighten Collet Nut securely to prevent
accessory from working out during operation of the
Grinder. Check tightness of Collet Nut before
operating the Grinder. Pay particular attention to
the fact that allowed speed of a mounted point is
lowered when the length of the shaft is increased
between end of collet and mounted point (overhang).
WARNING:
Incorrect combinations of grinding wheel, wheel guard and tool speed could result in injury.
Correct combinations are specified below:
Guard Part Number
Wheel Type
Wheel Diameter
in. (mm)
Maximum Wheel
Thickness
in. (mm)
Maximum Speed
rpm
AG121–106–4
27
4 (100)
1/4 (6.4)
15,000
AG20–106–3
27
3 (76)
1/4 (6.4)
26,250
PLACING TOOL IN SERVICE
LUBRICATION
Ingersoll–Rand No. 10
Ingersoll–Rand No. 67
Ingersoll–Rand No. 50
Ingersoll–Rand No. 68
Ingersoll–Rand No. 63
Ingersoll–Rand No. 77
Always use an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
For International – No. C18–C3–FKG0–28
After each two hours of operation, if an air line lubricator is
not used, inject 1/2 to 1 cc of Ingersoll–Rand No. 10 Oil into
the Air Inlet.
After each eight hours of operation, inject approximately
3cc for (TX Models) and 2 cc (for TXA Models) of
Ingersoll–Rand No. 67 or Ingersoll–Rand No. 77 Grease into
the Angle Grease Fitting.
Excessive lubrication will cause grease to work out around
the Arbor.
Do not mark any nonmetallic surface of this tool with
customer identification codes. Such action could affect tool
performance.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
FILTER
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
COMPRESSOR
(Dwg. TPD905–1)
