Ingersoll-Rand SS3L3, Owner'S Manual And Parts List

Page: 6 / 72

EN-6 22204929 Rev B
EN
INSTALLATION
SELECTING A LOCATION
GENERAL
Select a clean, dry, well-lighted indoor area with plenty of space for proper
cooling air flow and accessibility�� Locate the unit at least 12 inches (0 cm)
from walls, and make sure the main power supply is clearly identified and
accessible��
TEMPERATURE
Ideal operating temperatures are between 2°F and 100°F (0°C and 7��8°C)
If temperatures consistently drop below 2°F (0°C)�� locate the unit inside a
heated building�� If this is not possible, you must protect safety/relief valves
and drain valves from freezing��
CAUTION
Never operate in temperatures below 20°F (-6��6°C) or above
125°F (51��0°C)��
HUMID AREAS
In frequently humid areas, moisture may form in the bare pump and
produce sludge in the lubricant, causing running parts to wear out
prematurely�� Excessive moisture is especially likely to occur if the unit is
located in an unheated area that is subject to large temperature changes��
Two signs of excessive humidity are external condensation on the
bare pump when it cools down and a “milky” appearance in petroleum
compressor lubricant�� You may be able to prevent moisture from forming
in the bare pump by increasing ventilation, operating for longer intervals
or installing a crankcase heater kit��
NOISE CONSIDERATIONS
Consult local officials for information regarding acceptable noise levels in
your area�� To reduce excessive noise, use vibration isolator pads or intake
silencers, relocate the unit or construct total enclosures or baffle walls��
PERMANENT MOUNTING
WARNING
Remove the unit from the skid before mounting��
The unit must be permanently mounted�� When mounting the unit, bolt
the feet to a firm, level foundation (such as a concrete floor)�� Do not bolt
uneven feet tightly to the foundation, as this will cause excessive stress on
the receiver tank�� Use metal shims under the “short” feet if necessary��






TYPICAL PERMANENT MOUNTING (CUSTOMER -SUPPLIED
HARDWARE)
Flat Washer
3/8” Lag Screw
Floor line
Lag screw anchor
for concrete
Shim beneath
isolator washer,if
necessary
Isolator
Washer
INSTALLING THE AIR INLET FILTER
CAUTION
Do not operate the unit without air inlet filter(s)��
If the air around the unit is relatively free of dirt, install the air inlet filter(s)
at the inlet connection(s) at the bare pump�� If remote air inlet piping or
heavy duty filtration is required, contact your dealer for information��
INSTALLING DISCHARGE PIPING
If it is necessary to install air discharge and condensate discharge piping,
adhere to the following general guidelines�� Contact your dealer for more
information��
WARNING
Do not use plastic pipe, rubber hose, or lead-tin soldered joints
anywhere in the compressed air system��
WARNING
If an aftercooler, check valve, block valve, or any other restriction
is added to the compressor discharge, install a properly-sized
ASME approved safety/relief valve between the compressor
discharge and the restriction��
CAUTION
If you will be using Ingersoll Rand synthetic compressor
lubricant, all downstream piping material and system
components must be compatible�� Refer to the following material
compatibility list�� If there are incompatible materials present
in your system, or if there are materials not included in the list,
contact your dealer or call 1-800-AIR-SERV��



62215.10.56