D-1400-4 Page 4 of 16
3.5.
LOCATE VERTICAL C ON DOOR.
3.6.
MEASURE DISTANCE
“Y”
FROM VERTICAL C TO STOP SURFACE ON HINGE SIDE.
3.7.
SUBTRACT 1” FOR RECOMMENDED CLEARANCE. FOR DOOR STILES LESS THAN 2-3/4” WIDE, SUBTRACT 3/4”.
3.8.
LENGTH OF DEVICE FROM VERTICAL C TO CUT OFF LENGTH IS
“X”.
L
L
L
3.11.
CUT ACCESS SLOT IN CHANNEL COVER:
(A)
DRILL 11/16” HOLE AS SHOWN BELOW LEFT.
(B)
REMOVE MATERIAL AS SHOWN BELOW RIGHT. REMOVE BURRS.
“X”
(CUT OFF LENGTH)
“Y”
1” RECOMMENDED
8-3/4”
MINIMUM
3.9.
IF DEVICE IS LONGER THAN
“X”,
USE A
HACKSAW TO CUT CHANNEL AND CHANNEL
COVER AS SHOWN BELOW. REMOVE BURRS.
3.10.
DRILL HOLES IN CHANNEL AS SHOWN BELOW.
REMOVE BURRS.
“X”
(SEE STEP 3.8)
8-3/4”
MINIMUM
MAKE SURE CHANNEL IS
FLUSH TO TOUCHBAR
WHEN CUTTING
5/16”
5/16” DIA. HOLE
1-1/16”
3/4” DIA. HOLE
C DEVICE
L
REMOVE
TO MAKE
C DEVICE
L
5/16”
11/16” DIA.
HOLE
