31
( )
Book 54722160 (8/02)
SECTION 6 -- MAINTENANCE
GENERAL
In addition to periodic inspections, many of the compo-
nents in these units require periodic servicing to pro-
vide maximum output and performance. Servicing
may consist of pre--operation and post-- operation pro-
cedures to be performed by the operating or mainte-
nance personnel. The primary function of preventive
maintenance is to prevent failure, and consequently,
the need for repair. Preventive maintenance is the
easiest and the least expensive type of maintenance.
Maintaining your unit and keeping it clean at all times
will facilitate servicing.
Correct engine speed is critical to the operation of this
machine. Check the idle and full load rpm every three
months and adjust in accordance with the speed and
pressure adjustment instructions in this manual and
included on a decal on the machine. Correct speeds
are on the general data decal.
SCHEDULED MAINTENANCE
The maintenance schedule is based on normal opera-
tion of the unit. This page can be reproduced and used
as a checklist by the service personnel. In the event
unusual environmental operating conditions exist, the
schedule should be adjusted accordingly.
COMPRESSOR OIL LEVEL
The oil level is most consistent when the unit is RUN-
NING AT FULL LOAD and should be checked at this
time.The optimum operating level is midway of the
sight tube on the side of the receiver tank. See the de-
cal beside the sight tube. If the oil level is not in the
“OK” range, make appropriate corrections (Add or
Drain). A totally filled sight tube in which the level is not
visible indicates an over--full condition and requires
that oil be drained.
Compressor Oil
This machine was factory filled with Ingersoll--Rand
Pro Tec
R
Compressor Fluid (Ingersoll--Rand XHP505
for XHP900 models).
By continued use of Ingersoll--Rand compressor fluids
and filters, optional warranty will be extended for the
base airend (rotors, housings, gears and bearings)
when substantiated with proof of conformance to rec-
ommended maintenance intervals and purchase of
OEM Ingersoll--Rand filters and fluids.
Optional Warranty --
The earlier of 60 months from shipment to, or the accumulation of 10,000 hours of service
by the initial user. The optional warranty is limited to defects in major components (rotors, housings and bearings),
and is automatically available to the original user when he meets the following three conditions:
2. Submissions of proof that Ingersoll--Rand fluid, filters and separators have been used. Refer to the Operation
and Parts manual for the correct fluids, filters and separator elements required.
3. Submission of proof that maintenance intervals have been followed.
STANDARD
OPTIONAL
2 yrs/4000 hrs
3 yrs/5000 hrs
(100--185 CFM only)
100% parts and labor
100% parts and labor
WARRANTY
TIME
*BARE AIREND
* * AIREND COMPONENTS
5 yrs/10,000 hrs
100% parts and labor
100% parts and labor
100% parts and labor
0%
