Ingersoll-Rand CSAXHP1070WCAT, Operating & Maintenance Manual

Page: 27 / 59

Operating Instructions Operating & Maintenance Manual
Book: 23012958 (2-16-07) Rev. A 27
Air hose restraining cable installation:
Secure hose restraining cable at each end to prevent accidental hose whipping. At the
machine-side of the air hose, install and secure one end of the hose restraining cable on the
3” nipple on the inlet side of the 3” service valve. Install the other end of the hose restraining
cable over the main hose connector.
Install suitable 3” air hose between service valve on unit and point of air use. The air hose must
be rated for outdoor use and for pressurized air service. Minimum rating is 250°F (121°C) and
200 psig (HP) or 425 psig (XHP).
Before Starting
Open manual blowdown valve to ensure the separator has been vented of all pressure. Close
the valve before starting.
Inspect the complete installation including remote fuel lines (if any) and air hose routing and
connections.
Check battery for proper connections and condition.
WARNING
!
Combustible gas can cause severe burns, blindness or death. Keep
sparks and open flame away from battery.
• Check the compressor fluid level. Maintain the fluid level between bottom and
midway of the sight glass on the separator tank.
• Check engine oil level. The proper level is labeled on the engine dipstick. Add oil
when required. Do not overfill.
• To jump-start, connect the positive booster/charger cable to the 24VDC positive (+)
terminal of the battery. Then connect the negative booster/charger cable to the
engine block...Not to the negative (-) terminal of the weak battery. After starting,
disconnect the negative (-) cable from engine block; then from the booster battery/
charger. Disconnect positive (+) cable from both batteries.