InfraTec VARIOCAM HD, User Manual

Page: 24 / 94

Thermography System VarioCAM ® HD
7 . Introduction
22 © InfraTec GmbH 2016 User Manual
7.5 Inserting a memory card
The SD-card slot is located on the left-hand side of the camera. In order to guarantee the degree of
protection
IP54, the slot is protected by a cover
. Pull off the cover to insert a memory card and insert the
SD-card into the card slot. Please observe the proper orientation of the card ( ▲ to the top). Afterwards,
the cover must be re-closed. This is the only way to ensure the complete degree of protection of the
device.
7.6 Replacing the lens
Only replace the lenses in dry and low-dust conditions. When the lens is removed, the degree of
protection
IP54
of the system is no longer guaranteed!
Position the VarioCAM
®
HD on a solid, level underground so that the lens is directed towards you. Rotate
the lens on the thermography system counterclockwise as far as it will go and/or until the two red dots are
aligned. Then, remove the lens to the front.
In order to attach the lens, the red marking spots on lens and camera must be aligned. In this position,
the lens must be pressed slightly against the camera corpus and turned clockwise until the red dot of the
lens is aligned with the white dot of the camera.
7.7 Operation using the gigabit Ethernet (GigE) interface*
Please proceed as follows in order to connect the VarioCAM ® HD to a PC/notebook. The accessories
described are contained in the scope of delivery as an option*.
■ The Ethernet cable is used in order to establish a connection to the Ethernet interface of the PC
(RJ45 connector).
■ The 8-pin LEMO connector (blue mark) is connected to the left 8-pin LEMO socket (Fig. 18, blue
mark) on the camera.
Please make sure to establish the connection to the proper LEMO socket! Plug the LEMO connector
into the socket with the red dot directed to the top. Do not force the connector in!
VarioCAM®
HD
Ethernet
8 14
LEMO
Power supply
VarioCAM
®
HD with Ethernet cable and power supply
The Ethernet cable is used in order to connect the
thermography camera to the 8-pin LEMO socket (left-hand
side, blue mark).
The 14-pin connector of the wall plug transformer is
plugged into the right-hand side LEMO socket with the red
mark pointing to the top.
Fig. 18 VarioCAM
®
HD with Ethernet cable and wall plug transformer
InfraTec