Chapter 2: Installation
Daughter Board Installation
2-9
Figure 2-6: Connect the BBU to the Connector at the Back of the Controller Board
Step 5.
Replace the chassis top cover
. Once the battery charger board has been
installed on the controller board, the chassis top cover must be
reinstalled. For further instructions on how to reinstall the chassis top
cover, please refer to
Section 2.6.2
.
Step 6.
Attach the BBU to the enclosure
. Integrators can use the four, pre-
drilled mounting holes on the BBU to attach the BBU to a custom
designed enclosure.
2.9. Daughter Board Installation
2.9.1 About Daughter Board Installation
♦
The optional, separately purchased daughter board allows you to add an additional
four SCSI-320 I/O channels to the SR controller.
♦
The daughter board, like the controller board, is a very sensitive component and must
be treated carefully. All anti-static precautions must be strictly adhered to and all the
controller safety precautions observed.
2.9.2 Daughter Board Installation Procedure
Step 1.
Remove the chassis top cover
. Before installing the daughter board,
remove the chassis top cover. For further instructions on how to remove
the top cover, please refer to
Section 2.6.2
.
Step 2.
Install the daughter board
. The daughter board is mounted on four pre-
installed spacers located in the middle of the controller board, just in
front of the SCSI connectors. Place the daughter board onto the docking
connectors so that the retention screw holes on the daughter board are
clearly aligned with the spacers.
