4-9
EonStor GSa 5000 Series Hardware Manual
3. Orient and insert the replacement FBM’s notch to the base board’s slot guide (A) in a 45° angle,
place on top of the base board with the notch on the screw hole (B), then secure the FBM to the
board with the screw that you removed in step 2 (C).
4. Insert the controller back to the enclosure.
5. Reconnect the cables and power cords, then turn on the system.
Notch
Base board
4.1.5 Replacing the host/expansion board
Before replacing the host/expansion board to the controller, you must take note of the following
considerations:
•
A controller/host board downtime may occur if you replace a host/expansion board for an upgrade.
•
The firmware automatically restores the system to its factory settings when adding or replacing a
host board.
To replace the host/expansion board:
1. Shut down your system, unplug the power cords and cables, then remove the controller. Wait for a
minute for the remaining electric current to dissipate.
NOTE:
4.1.2 Replacing the controller module
for details.
