129
4.
Remove the drive tray
. Pull the tray one inch away from the enclosure. Wait for
at least 30 seconds for the disk drive to spin down, and then gently withdraw the
drive tray from the chassis.
5.
Remove four retention screws
(two on each side). The screws secure the hard
drive to the drive tray.
Without mux board
With mux board
3.5 inch tray
2.5" SAS HDD (without MUX)
2.5" SATA HDD (with MUX)
MUX board screw locations
2.5 inch tray
2.5 inch SAS hard drive
2.5 inch SATA hard drive
6.
Replace the drive.
After swapping the drive, fasten the retention screws back.
Refer to screw locations in the previous step.
7.
Insert the drive tray back into the enclosure.
Install the drive tray with the
front bezel open. When fully inserted, close the front bezel.
