Infopia Finetest Auto-coding, User Manual

Page: 8 / 23

1 5
Setting the Meter
1 4
Setting the Meter
Year
After pressing and releasing either
▲
or
▼
buttons to set
the year (from 2007 to 2099), confirm with .
Date / Time
After pressing and releasing either
▲
or
▼
buttons to set
the date and time, confirm each with .
Test unit
Press and release either
▲
or
▼
buttons to set the test
unit (mg/dL or mmol/L), confirm with .
Caution
1.
**VERY IMPORTANT:
Correct test unit.
Your
finetest Auto-coding TM
Meter is pre-set to mg/dL as test unit. A wrong test unit
will lead to wrong test result display! Please consult your healthcare professional
if you’re not sure which test unit to use. Stored test results are displayed correctly
after re-setting the test unit. See also conversion table on page 38
2. Without setting the date properly, the average glucose level and the results in
memory will not show proper values. It is recommended to set the meter before
use and when new batteries are installed.
3. Yon can’t test your blood glucose while in the setting mode.
4. To turn the meter off during setup, press for at least 3 seconds
Alarm on/off
After pressing and releasing either
▲
or
▼
buttons to turn
the alarm on/off, confirm with .
Number of days for average
After pressing and releasing either
▲
or
▼
buttons to set
the number of days for average calculation (3 different
possible), confirm with .
Alarm time
After pressing and releasing either
▲
or
▼
buttons to set
the alarm hour and minute, confirm with .
Alarm
After programming the number of desired alarms (5
alarms possible), confirm with .