InFocus LitePro 210, User Manual, Page: 59 / 86

46
M a i n t e n a n c e
After you make sure that the condition that made the fuse blow
no longer exists, follow these steps to replace the fuse:
1
Turn off the projector by pressing the “O” side of the power
switch.
2
Unplug the power cord.
3
Remove the fuse holder, located just above the power cord
connector. Pull out the fuse holder with a small, flat-blade
screwdriver, key or coin (Figure 40).
CAUTION: The 6.3A IEC 127
type fuse is required in Europe. In
countries with low main voltage,
you may need the 8.0A fuse to
avoid repeated (nuisance) blowing
of the 6.3A fuse. Both fuses
provide protection from risk of fire.
Do not use the projector if
repeated blowing still occurs after
switching to the 8.0A fuse. Call In
Focus Technical Support for
assistance.
F
IGURE
40
Removing the fuse holder
4 Remove the blown fuse from the fuse holder (Figure 41).
F
IGURE
41
Removing the fuse from the fuse holder
5 Push the spare fuse into the holder until it is securely seated.
6
Place the fuse holder back in position (Figure 42).