Initial Network Automation Appliance Configuration
19
Infoblox Installation Guide
Do you want to generate a new HTTPS Certificate? (y/n) [n]:
y
4.
Enter the local domain name in which the controller resides. This value is used for truncating device names in
Network Automation data sets throughout the system.
Domain Name 1 (e.g., example.com) []:
corp100.com
Domain Name 2 (optional) []:
5.
Enter the time server IP address if one is available or is necessary:
Time Server [us.pool.ntp.org]:
6.
Enter the time zone region by typing in the suggested numeric value from the list.
Enter choice (0-47) [0]:
45
7.
Enter the time zone location by typing in the suggested numeric value from the list:
Choose a location within your time zone.
0. Alaska 1. Aleutian 2. Arizona 3. Central
4. East-Indiana 5. Eastern 6. Hawaii 7. Indiana-Starke
8. Michigan 9. Mountain 10. Pacific 11. Samoa
Enter choice (0-11) [0]:
10
8.
Follow the steps for configuring the management port IP settings:
+++ Configuring Management Port Settings
You must configure an IPv4 or IPv6 address/mask on the management port.
Network Automation can perform analysis from the management port or a separate
scan port.
IP Address (optional) []:
10.120.25.212
Subnet Mask (optional) []:
255.255.255.0
IPv6 Address (optional) []:
IPv6 Prefix (optional):
You must provide either an IPv4 gateway, an IPv6 gateway, or both.
IPv4 Default Gateway (optional) []:
10.120.25.1
IPv6 Default Gateway (optional) []:
Note:
You must provide either an IPv4 or IPv6 gateway address, or both, depending on the Network Automation
IP address.
The
configure server
command then requests configuration of the Scan port if you are running two-port
configuration:
Do you want to configure the Scan Port? <y/n> [n]:
Entering N instructs the
configure server
command to skip IP configuration for the Scan port.
