2
No.
Name
Description
1
Power LED
On:
The switcher is powered on.
Off:
The switcher is powered off.
2
Status LED
On:
The switcher is outputting at least one video source.
Blinking:
The switcher is in standby mode.
Off:
The switcher is outputting Guide Screen.
3
Source Switch
VGA IN ~ USB-C IN Buttons:
Short press to output or stop outputting the corresponding video source.
Hold press to output the corresponding video source in full screen mode.
VGA IN ~ USB-C IN LEDs:
On: The corresponding video signal is valid and is being output.
Blinking quickly: The corresponding video signal is valid but is not being output.
Blinking slowly: The corresponding video signal is being output but is not valid.
Off: The switcher is in standby mode. / The corresponding video signal is neither valid nor
being output.
4
HDMI 2 Output
HDMI2 Output button: press to switch between Follow mode and Matrix mode for HDMI Output
2.
To switch to
Follow
mode: long press the HDMI2 Output button until the Follow LED lights
up. In Follow mode, HDMI OUT 2 follows HDMI OUT 1 to output the same video content as
that of HDMI OUT 1.
To switch to
Matrix
mode: short press the HDMI 2 Output button. In Matrix mode, HDMI
OUT 2 will output a specific video source in single view (specified by Telnet API or Web UI);
continue to short press the button, the HDMI OUT 2 will cycle through the hardware video
sources (VGA > HDMI 1 > HDMI 2 > USB-C > VGA >
…
) for output.
LED Status:
Follow LED: Lights up when Follow mode is selected.
Matrix LED: Lights up when Matrix mode is selected.
5
USB
Connect to a U-disk for firmware upgrade.
Connect to the USB Dongle for pairing up with each other.
6
Reset
Hold press this button for five or more seconds and then release, it will automatically reboot and
restore to its factory defaults.