3B
MFD ASSEMBLY INSTRUCTIONS
CABLE AND PULLEY INSTALLATION
N.
Insert the Weight Pin into one of the 5lb. weight plates. Remove the 3/8” cap
screw from the Top Weight. Lift the “U”-Bracket Weldment from the Top
Weight and selector stem. Install the loop of Weight Pin lanyard over the
round clevis beneath the “U”- Bracket. Re-install the “U”-Bracket Weldment
to the Top Weight.
O.
Place MFD cable under 1 – 4 ½” Pulley and fasten pulley to “U”- Bracket
above Top Weight using 1 – 3/8 x 2” bolt, 2 - 3/8” flat washers, and 1 – 3/8”
nut.
P.
Route cable ends up to the Upper Pulley Bracket. Place a 4 ½” Pulley under
each cable end and insert the pulleys within the Pulley Bracket plates.
Fasten using 2 – 3/8” x 1 ¾” bolts, 4 – 3/8” washers, and 2 – 3/8” nuts.
Q.
Route the cable ends forward to the L/H and R/H Cams and install the ball
ends into the hooks welded on the Cams.
PADS
R.
Attach the Bottom Pad and Back Pad using 4 – 3/8” x 1 ¼’ bolts and 4 – 3/8”
flat washers.
5B
CABLE ADJUSTMENT
S.
Once the Multi-Fly/Delt is completely assembled, loosen the jam-nuts behind
the rubber bumpers above the Cams. Thread the bumper in or out to remove
slack from the cables and align the arms. Make sure that the Weight Pin still
engages all weight plates with the Selector Stem. Once the cable tension is
correct re-tighten the jam-nuts.
8