InfiRay Outdoor
•
AFFO Series
•
Operating Manual www.infirayoutdoor.com
All rights reserved and shall not be copied and distributed in any form without written permission
⚫
The battery is short circuit protected. However, any situation that may
cause short-circuiting should be avoided.
⚫
Don’t dismantle the battery from the device.
⚫
The battery capacity may decrease when using the battery in negative
temperature, that is normal, not a defect.
⚫
Avoid using the battery at the temperature above the temperature
shown in the table, this may decrease the battery’s life.
⚫
If the thermal imaging monocular is not used for a long time, recharge
the device every 2 months at least and charge to 40%-50% power, then
store the device in a dry and ventilated environment.
⚫
Partial charging the battery is necessary if the battery is planned to be
idled for long time. Avid fully charged or discharged.
⚫
Keep the battery out of the reach of children.
8
LED Light
The AFFO series is equipped with the LED light
(7)
. You can quickly turn
on/off the LED light
(7)
only when the AFFO is turned off
⚫
When the device is powered off, keep pressing down the
Up (5)
button
to turn on the LED light, and release the
Up (5)
button to turn off the LED
light.
⚫
Please note that when the device is turned on, the LED light is
unavailable.
9
Operation
⚫
Open the lens cover
(9)
.
⚫
Press and hold the
Power (6)
button for 2s to turn on the thermal
imaging monocular.
⚫
When an infrared image is displayed in the eyepiece, the thermal
imaging monocular enters the operating status.
⚫
Rotate the diopter adjustment knob
(2)
to adjust the resolution of the
icon on the display. The diopter adjustment knob is used to adjust the
eyepiece diopter for users with different degrees of myopia.
⚫
Setting the image mode
: briefly press the
Up (5)
button
to set the
image palette mode. There are five modes for selection: white hot
(
), black hot (
), red hot (
), pseudo color (
) and target
highlight (
). The icon on the top status bar is updated in real-time.
⚫
Setting the display brightness:
press and hold the
M (4)
button to set
the display brightness level from level 1 to level 5 in the menu (refer to
