CleanMate 365
CleanMate 365
CleanMate 365
CleanMate 365
Preparations
1.Find a proper place (we recommend a hard surface floor) to put the Self-Charging
Home Base in the room. Leave about 20 inch (50 cm) clearance around the Home
Base.
2.Align the metal plate under the Base with the wall. Plug the charger to AC power
outlet, and the other end to the DC input connector on the back of Home Base.
Do not leave loose wires around the Home Base.
3.Make sure the blue LED light on the Home Base is on. This means that the Home
Base has been powered on, and it is ready to charge the QQ-2L.
Testing the Home Base
1.Put the QQ-2L on the floor close to the Self-Charging Base. Turn the QQ-2L on by
pressing its power switch button. Now press the “HOME” key on remote control
unit. The QQ-2L should return to the Home Base automatically for self-charging.
2.Make necessary adjustment to the Home Base if the QQ-2L cannot dock on the
Home Base properly.
Using the Home Base
1.When its battery is running low, or after it has finished the cleaning job, QQ-2L
will try to automatically return to the Home Base to re-charge itself. In case the
QQ-2L is unable to find the Home Base before battery power is depleted, you can
always charge it manually. Just un-plug the AC adapter from the Home Base,
and plug it to the DC input connector on QQ-2L.
2.When you charge the QQ-2L manually, the battery will be charged no matter the
QQ-2L is on or off.
3.If you press “GO” key after the automatic self charging process, the cleaning
time setting on QQ-2L will be re-set to 40 min.
CleanMate 365
CleanMate 365
Side Brush Installation and Removal
To remove the Side Brush, use a Philips head screwdriver to remove the screw
in the center of the Side Brush Assembly by turning it counter-clockwise.
To install the Side Brush, place the Philips head screw through the center hole
of the Side Brush assembly, and align the screw with the hole in the slot for the
Side Brush. Attach the screw by turning it in a clockwise direction, until the
screw is firmly in place.
Rolling Brush Installation and Removal
Ensure that the power switch of the unit is set to the 'Off' position, and turn
the unit over on it’s top, with the back of the unit facing you.
Align the slotted end of the rolling brush with the slot in the flexible
insert in the right side of the rolling brush compartment (near the side
brush) and press it into place.
Press the free end of the rolling brush down into the rolling brush
compartment, and align the free end with the plastic insert on the left side
of the compartment. Slide the rolling brush to the left to secure it in place.
Fragrance Installation and Removal
This Intelligent Automatic Vacuum has a compartment built into it for
adding fragrance to the air as the unit cleans. Any solid scent packet,
insert, or dryer sheet can be used.
DO NOT use any type of Liquid or Oil Fragrance with this unit.
1.Press the "Dust Bin Release Button" to release the dust bin cover.
See the arrow in Illustration 1.
2.Remove the dust bin cover as shown in Illustration 2.
3.Remove the dust bin from its compartment as shown in Illustration 3
4.Place the fragrance pack into the compartment as shown in Illustration 4.
Self Charging Base
Self Charging Base
Installing Basic Accessories
Installing Basic Accessories
Installing Basic Accessories
Installing Basic Accessories
10
11
