��������
���
���
����
��������
�����
�����
���������
�����������
������������
����������
������������
����
�������
�������������
����������������������
��������������
�������������������������
���������
��������
�������������
�����������
�����������������
Programming Complete
1. Once you pulled and released the trigger the number of times necessary to set the
function, wait a few seconds. The LED will flash red/green/orange in rapid succession
(numerous times) to
let you know that the new setting has been saved.
2. After this, the LED will return to the color representing what the current programming
menu item is. At this point, you can once again pull and release the trigger to toggle
between Dwell, Debounce, Eye Mode, Etc.
You can perform a complete reset, and restore all of the settings to the factory defaults. To do this, just hold down the
trigger for a full 6 seconds. It does not matter what programming mode you are in. The LED will start flashing red, letting
you know that a reset operation is being performed. After this occurs, you will be back to the programming starting point.
DO NOT release the trigger until you see the LED flashing red of the reset will not occur.
MAINTENANCE
General Care and Cleaning
The LEGEND should only be cleaned externally using a synthetic oil moistened cloth only.
•
Under NO circumstances should you use hydrocarbon-based oil, as these will cause
extreme damage to the internal seals, e.g. WD40, Vaseline, Engine oil, or 3in1.
• The ram shaft and internal parts that are accessible during disassembly should be
lubricated with oil (lightly), DO NOT use grease.
• The frequency of lubrication should be before every event or at least every 20,000 shots.
• The LEGEND should never be immersed into water or damage will occur to the electronics.
Ball Detent Replacement
There are two anti-double ball detents that can be removed for cleaning or replacement. These are located beneath the
eye covers on either side of the body.
