LED MENU
LED Colors and Meanings
The LED used by the LEGEND can light up in one of 3 colors. The LEGEND uses this to indicate to the user when certain
events are occurring. This is a breakdown of what the LED states represent:
Blinking Green (once per second)
Normal operation, anti-chop system is enabled,
Eye Mode 2 (rate of fire capped at user preset).
Blinking Green (twice per second)
Normal operation, anti-chop system is enabled,
Eye Mode 3 (unlimited rate of fire).
Blinking Orange
Normal operation, anti-chop system is disabled.
Blinking Red
Battery is low.
Red/Green Toggle
There is an error with the anti-chop system (Eye
Mode 3 only)
Flickering Green
Object is detected in the breech.
Tournament Lock
Some tournament series may call for a tournament lock on the electronics. This means that you my not be able to change
certain settings during league play
To put the LEGEND into tournament lock mode
1. Turn the LEGEND off.
2. Remove the left grip panel and circuit board.
3. On the back of the circuit board there a five pins, starting with one at the top and five on the bottom.
4. Use a small piece of wire and short pins 2 to 5.
5. While holding the wire on pins 2 and 5, turn the power on. The LED will light up green,
orange, red in that sequence.
6. Let it run through the sequence a few times and turn the power off.
7. Now you MUST remove the battery and wait a 5 seconds.
8. Replace the battery, circuit board and grip panel.
9. When you turn the LEGEND back on the LED should blink slowly red, instead of green.
Trigger Programming
The Dwell, Debounce, Eye Mode, BIP Delay, MROF Cap, Eye Power and Firing Mode functions are programmable by
following these instructions:
1. Turn the LEGEND off.
2. During programming, make sure that your marker has a barrel-blocking device in place
and the air/nitrogen supply is disconnected. Although it is not possible to fire the marker
while in the programming mode, it is always good to practice safe marker handling.
3. Pull the trigger and hold it in the back position.
4. Now turn your LEGEND on by pressing the button on the back of the trigger frame.
During this time the LED will light up green.
5. Now release the trigger. The LED will change to red. The marker is now in the
trigger-programming mode
