10
Ordercode: 41526
Infinity iW-740 RDM
Control Modes
There are 4 modes:
Stand-alone (built-in programs)
Master/Slave
DMX512 (21CH, 28CH, 43CH)
DMX (28CH+15CH)
One Infinity (Built-in Programs)
01)
Fasten the effect light onto firm trussing. Leave at least 1 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Plug the end of the electric mains power cord into a proper electric power supply socket.
04)
When the Infinity is not connected with a DMX cable, it functions as a stand-alone device.
05)
Please see page 23 for more information about the
built-in programs.
Multiple Infinity’s (Master/Slave control)
01)
Fasten the effect light onto firm trussing. Leave at least 1 meter on all sides for air circulation.
02)
Always use a safety cable (ordercode 70140 / 70141).
03)
Plug the end of the electric mains power cord into a proper electric power supply socket.
04)
Use a 3-pin XLR cable to connect the Infinity.
The pins:
1.
Earth
2.
Signal (-)
3.
Signal (+)
05)
Link the units as shown in fig. 04. Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third and fourth units. You can
use the same functions on the master device as described on page 23 (Built-in Programs). This means
that you can set your desired operation mode on the master device and all slave devices will react
the same as the master device.
Multiple Infinity’s (
Master/Slave control)
Fig. 04
