Infinea X DF User Manual
10
Charge Infinea X DF
You can charge the Infinea X DF by either an AC wall outlet or by
replacing the battery. Pass-through charging to your iOS device is
supported.
Based on charging requirements, the Infinea X DF and iOS device
cannot be charged together using a USB cable to a PC connection.
Battery Status Indicator
To check the battery life of the unit, press the battery status button on
the bottom left or right-hand side, and then observe the color of the LED.
Note: if the green LED is not illuminated on the unit while charging,
verify the connector is properly attached and the unit is seated
securely in the charging cup accessory. If a problem persists, contact
https://ipcmobile.com/support.
Charge Battery
You can charge up to ten batteries at once using the multi-bay charger.
Each battery slot in a single LED charge.
Note
Standard batteries take approximately 2.5 hours to fully charge. The
extended battery requires about 5 hours to charge. When the LED
is green, the battery is fully charged; red indicates charging is in
progress.
Charging times for the Infinea X DF is three hours with or without the
standard battery inserted. If back-up charging is enabled and both iOS
device and Infinea X DF are fully discharged, insert a new, completely
charged standard battery into the unit and charge for about 10-15
minutes using the charging cup. After 15 minutes, remove the charging
cup so the Infinea X DF provides back-up charging to the iOS device, as
needed.
Note
When not in use, remove the battery and turn off the iOS device.
Status
Description
100-75%
Solid green
74%-50%
Blinking green
49%-25%
Blinking orange
24%-10%
Blinking red
9%-1%
One LED blinking red indicating emergency low
battery status
When the remaining battery capacity is below 15%, the automatic charge on the
iOS device stops.
•
Standard battery capacity is 1900mAH.
•
Extended battery sold separately is 3800mAH.