InfiNet Wireless Router
Quick start guide
Copyright © 2004-2006 by InfiNet Wireless Limited.
7
I.
Getting Started
This document is designed to help engineers/technicians in rapid configuring of
InfiNet Wireless Routers. The document includes detailed instructions for first
configuration steps and configuration scenarios for typical network topologies.
1.
Scope of document
This document consists of the following chapters:
Getting started
This chapter includes the information about this document purpose and structure.
Getting access to the router
The chapter describes how to get access to the router via Console Port and to
configure Ethernet port.
Point-to-point configuration
This chapter includes a comprehensive list of instructions for point-to-point link
configuration including providing LAN connectivity.
Point-to-multipoint configuration
The chapter briefly describes the difference between PTM and PTP topology
when building a network based on InfiNet Wireless Routers. Due to similarity of
PTM and PTP configuration it mostly references a previous chapter.
Performing outdoor testing
The chapter contains a list of requirements for outdoor testing. Also a basic steps
for link improvement and antenna alignment is presented.
Connectors soldering schemes
Contains connectors soldering schemes for Console cable and for ODU-IDU
service cable
2.
Abbreviations
The following abbreviations are used in this document:
•
BS – Base Station
•
CPE – Customer Premises Equipment (also called
subscriber
or
subscriber unit
)
•
ODU – Outdoor Unit (relevant for 5000-O and 5000-M modifications)
•
IDU – Indoor power supply Unit (relevant for 5000-O and 5000-M
modifications)
•
RF cable – Radio Frequency cable to connect ODU and antenna/Router
and antenna for 5000-O and 5000-I modifications correspondingly
•
LOS – Line-of-Sight
•
STP cable – Shielded Twisted Pair cable to connect ODU and IDU
(relevant for 5000-O and 5000-M modifications)
•
PTP – Point-to-Point topology
•
PTM – Point-to-Multipoint topology
