User Manual
Please read the Important Notice and Warnings at the end of this document
Revision 1.4
www.infineon.com
page 1 of 47
2020-07-16
AN2019-04 EVAL-M3-IM564 User Manual
EVAL-M3-IM564 User Manual
iMOTION
™
Modular Application Design Kit
About this document
Scope and purpose
This user manual provides an overview of the evaluation board EVAL-M3-IM564 including its main features, key
data, pin assignments and mechanical dimensions.
EVAL-M3-IM564 is an evaluation board as part of the iMOTION
™
modular application design kit. This power
board includes a PFC integrated 3-phase CIPOS
™
Mini intelligent power module (IPM) for motor drive
applications. In combination with the control board equipped with the M3 30-pin interface connector such as
EVAL-M3-102T, it features and demonstrates Infineon’s CIPOS
™
Mini IPM technology and advanced motion
control engine (MCE 2.0) technology for permanent magnet motors drive over the full speed range.
The inverter section has 600 V of voltage and 20 A of current rating, and the PFC section has 600 V of voltage and
20 A of current rating. It is optimized to major home appliances like air conditioners and low power motor dirve
applications with high-frequency switching operation of power factor correction.
This evaluation board EVAL-M3-IM564 was developed to support customers during their first steps designing
applications with CIPOS
™
Mini PFC integrated IPM IM564-X6D/IM564-X6DS and running any permanent magnet
motor via sensorless sinusoidal control.
Intended audience
This user manual is intended for all technical specialists who know motor control and high-power electronics
converters. The board is intended to be used under laboratory conditions.
Attention:
The Evaluation Boards and Reference Boards as well as the information in this document are
solely intended to support designers of applications in evaluating the use of products from
Infineon Technologies for their intended applications.
Environmental conditions have been considered in the design of the Evaluation Boards and
Reference Boards provided by Infineon Technologies. The design of the Evaluation Boards
and Reference Boards has been tested by Infineon Technologies only as described in this
document. The design is not qualified in terms of safety requirements, manufacturing and
operation over the entire operating temperature range or lifetime.
The Evaluation Boards and Reference Boards provided by Infineon Technologies are subject
to functional testing only under typical load conditions. Evaluation Boards and Reference
Boards are not subject to the same procedures as regular products regarding returned
material analysis (RMA), process change notification (PCN) and product discontinuation (PD).
Evaluation Boards and Reference Boards are not commercialized products, and are solely
intended for evaluation and testing purposes. In particular, they shall not be used for
reliability testing or production. The Evaluation Boards and Reference Boards may therefore
not comply with CE or similar standards (including but not limited to the EMC Directive
2004/EC/108 and the EMC Act) and may not fulfill other requirements of the country in which
they are operated by the customer. The customer shall ensure that all Evaluation Boards and