KIT_XMC4400_DC_V1
Drive Card XMC4400 V1
Hardware Description
Board User's Manual
12
Revision 1.0, 2013-11-05
2.4.1
On-board USB Debugger
The on-board debugger [1] supports
Serial Wire Debug
Full Duplex UART communication via a Virtual COM port
o
PC_RXD
P5.1 USIC0CH0.DOUT0
o
PC_TXD
P5.0 USIC0CH0.DX0D
[1] Attention: The firmware of the on-board debugger requires the latest J-Link driver (V4.62 or higher) and a
Serial Port Driver (CDC driver) installed on your computer. Please check “Install J-Link Serial Port Driver”
when installing the latest J-Link driver (see Figure 7)
Figure 7
Installation of Serial Port Driver
The on-board debugger can be accessed through the Debug USB connector shown in Figure 8. The Debug
LED V402 shows the status during debugging.
Figure 8
On-Board USB Debugger
Debugger.emf
On-board
Debugger
Infineon
Debug
Connector
CAN
Interface
Debug USB
Connector
isolation
SWD
&
UART
Debug
LEDs
isolated
CAN
transceiver
