User guide
3 of 19
Revision 1.0
2019-05-07
Demoboard BTS3011TE
User Manual
Getting Started
1
Getting Started
1.1
BTS3011TE Shield Overview
The 12V low-side switch demoboard with one BTS3011TE from Infineon Technologies is a flexible evaluation
board dedicated to drive all kinds of loads up to 1kHz, especially motors and capacitive-like loads. This
demoboard is compatible with Arduino UNO shield.
The demoboard can be controlled either with the general logic I/O-ports of a microcontroller or with a PWM
signal from a waveform generator. It includes typical schematic to control the BTS3011TE.
This shield offers a quick evaluation of the product functions
like the “
Status
”
latch feedback, dedicated logic
supply
(logic is independent of Input) and all protections, e.g. “
Current protection
”, “Over temperature
protection”
.
WARNING: Please refer to BTS3011TE datasheet for details on functionalities and parameters values. This
user manual does not replace the datasheet and user must be aware of limitations before turning on and
supply
.
The shield can be easily connected to any Arduino UNO board via headers. Code and GUI is available for
Arduino UNO. No code/interface is available for XMC1100 but XMC1100 can be easily programmed through
Arduino IDE: Please check the following link for detail:
https://github.com/Infineon/XMC-for-Arduino
Figure 1
Example figure
