10
Removing/Replacing the Power Stick
The D-TEK Select uses a pre-assembled power stick.
Remove the battery compartment door on the back of the D-TEK Select by
pressing on both release buttons on the grip and pulling the door straight out. The
power stick is connected to the PCB board via a miniature electrical connector.
Disengage the connector and slide the power stick out of the D-TEK Select.
Slide the new stick into the D-TEK Select and push the miniature connector on the
power stick into the mating half on the PCB board. Do not bend the PCB board’s
connector away from the board. Once the power stick is in place, close the battery
compartment by aligning the two tabs and sliding the door straight in until it
latches. Ensure the wire leads on the power stick are not pinched in the door.
Allow 10 hours to fully charge the new power stick.
NOTE:
If the D-TEK Select does not power up after the power stick is replaced,
check that the key connector on the power stick is mated properly to the
connector on the circuit board. Reverse the connection if necessary and
power up again. If the Hi/Lo indicators flash in a rapid, alternating manner
when the AC adapter is connected, the power stick is installed
backwards.
