P. I. E. INEL Sp. z o. o., ul. Mostowa 1, 80-778 Gdańsk, [email protected]
www.inel.gda.pl
return to the upper limit and confirm that programming is
finished.
WARNING! Stopping the motor with a remote control
during automatic programming will automatically enter
the SEMI-AUTOMATIC programming mode.
5.3. SEMI-AUTOMATIC LIMIT PROGRAMMING
UPPER LIMIT
Upper limit in the desired position (if no stoppers are
present):
a. Press and release the "
↑
" button on the remote control.
b. Press the STOP button on the remote control in the desired
upper limit position. You may correct this position after
switching the remote into shutter mode.
c. To confirm the upper limit, press the STOP button on the
remote. The roller blind will confirm the registration of the
upper limit by making two sequences of short down-up
movements.
d. At this point start programming the lower limit.
OR
Upper limit by overload (if stoppers are used):
a. Press and release the "
↑
" button on the remote control.
b. Press the STOP button after the drive stops (if the button is
not pressed within 3 s the drive will enter automatic
programming mode). You may correct this position after
switching the remote into shutter mode.
c. To confirm the upper limit, press the STOP button on the
remote. The roller blind will confirm the registration of the
upper limit by making two sequences of short down-up
movements.
d. At this point start programming the lower limit.
LOWER LIMIT
Lower limit in the desired position:
a. Press and release the "
↓
" button on the remote control.
b. Press the STOP button on the remote control in the desired
lower limit position. You may correct this position after
switching the remote into shutter mode.
c. To confirm the lower limit, press the STOP button on the
remote. The roller blind will confirm the registration of the
lower limit by making three sequences of short up-down
movements.
d. Press and release the "
↑
" button on the remote, the roller
blind will start moving towards the upper limit, where it will
confirm the end of programming.
OR
Lower limit on sill:
a. Press and release the "
↓
" button on the remote control.
b. The drive will stop on the sill. You may correct this position
after switching the remote into shutter mode.
c. Press and release the STOP button to confirm the lower
limit. The roller blind will confirm the registration of the
lower limit by making three sequences of short up-down
movements.
d. Press and release the "
↑
" button on the remote, the roller
blind will start moving towards the upper limit, where it will
confirm the end of programming.
In the semi-automatic lower limit programming phase (on sill),
the motor will attempt to detect the type of hangers used. After
the drive detects the sill, it will make another 1/4 revolution. If
no overload is detected at this point (lower RPM), it will move
back by 1/4 revolution (no blocking hangers detected). If
overload is detected during the 1/4 revolution, the motor will
stop at the position of overload (blocking hangers detected).
Press the "
↑
" to set the limit.
6.
RETURN TO FACTORY MODE
Press the ▲ and ▼ buttons on the remote at the same time, the
motor will make a short up-down movement, then press STOP.
The motor will make another short up-down movement.
Perform this operation 4 times.
7.
OBSTACLE DETECTION OPERATING PRINCIPLE
Before limit positions are set (factory mode), the motor will
only detect decreased rpm caused by overload. The
obstacle detection function will be activated only after both
limit positions are set.
Obstacle detection works only for downward movement.
During upward movement, the drive will stop if decreased
rpm are detected.
If the roller blind stops unexpectedly (an obstacle appears),
the drive will move in the opposite direction in order to
release curtain tension, allowing you to remove the obstacle.
