IndigoVision HD Ultra X Bullet, Web Configuration Manual

Page: 11 / 15

11 Web Configuration Guide - v1
• Enter NTP server address and click Apply .
2. To enable DST, configure the following on the Setup > System > DST Settings page
if required:
• DST Type
• Start Time
• End Time
Modify IP address and network settings
By default, the HD Ultra X Range cameras cameras use DHCP to get an IP address on initial
startup. Alternatively, you can statically configure the IP address and network settings to
allow the camera to work on the required network.
Use the Web configuration pages to change the IP address and network settings.
1. Enter the following network configuration on the Setup > Network > Network
Settings page if required:
• IP address
• Subnet mask
• Default gateway
• DNS servers
Control Center requires that the IP address for a device in a site remains fixed. If the DHCP
server has been configured to lease addresses from an address pool, rather than based on
MAC address, the device will not work correctly with Control Center.
Modify camera settings
After the camera has been installed in its final location, you need to adjust the image settings
to ensure that you have the best quality picture.
Use the Web configuration pages to change the camera settings.
1. Adjust the image settings to fit the scene using the options on the Setup > Camera
page.
Adjust the required settings manually, for example:
• Brightness
• Contrast
Configure CyberVigilant
You can use the Web configuration pages to configure the CyberVigilant settings on the
camera if required:
1. Click Setup > Security > CyberVigilant .
2. Enter the IP address for the authorized device.
3. Click Add .
4. Repeat step 2 and step 3 for all required IP addresses.
5. Select Enable CyberVigilant .
6. Click Apply .
3 Initial camera configuration HD Ultra X Range - Camera