Chief Warm or Hot Engine Starting
1. Place the engine stop switch in the RUN position.
2. Turn the ignition switch to the ON position.
3. Disengage clutch.
4. Ensure that throttle is
fully closed
5. Press the starter switch to activate the electric starter.
DO NOT, UNDER ANY CONDITION, OPEN THE
THROTTLE WHILE STARTING THE ENGINE.
If the engine still does not start, remove the spark plugs
a second time. A nominal waiting period of 20 minutes
may be required to allow the excess gas to evaporate
from the cylinders. Replace the spark plugs and perform
the normal starting procedure.
DO NOT, UNDER ANY CONDITION, OPEN THE
THROTTLE WHILE STARTING THE ENGINE.
WARNING!
Starting the engine with the spark plugs removed can
cause a fi re hazard and damage the ignition system if not
grounded properly.
WARNING!
As with any vehicle, do not start, idle or operate this
motorcycle in areas where combustible materials such
as grass, hay or leaves can come into contact with the
hot exhaust system, as these materials could be ignited
and cause a fi re.
Stopping the Engine
To stop the engine, turn the ignition/light key to the
OFF position.
If the engine stalls or stops suddenly, turn the ignition
switch to the OFF position to prevent battery discharge.
Shifting Gears
Starting the Motorcycle in Motion
To engage fi rst gear from a start, pull the clutch lever
towards you to fully disengage the clutch. With your
left foot, push the forward shifter lever down fi rmly but
gently to engage fi rst gear. With the motorcycle upright
and the engine idling, release the clutch lever slowly
to engage the clutch and at the same time, open the
throttle gradually.
Note:
Always start the motorcycle in motion using fi rst
gear.
Starting and Riding
28
Summary of Contents for Chief 2010
