Every 600 hours
Brake kit
Check that the brake block wear surface is
sufficiently thick. The brake block is changed
when the thickness of the wear surface is
below 0.2 mm.
Dismantle the brake kit, remove the dust
from the open tracks in the brake block and
rotate the bearing in the brake block one
turn. This is done to increase the service life
of the bearing. If the brake kit bearings have
any play, start to stick, or if the rubber seal
is damaged, the bearing should be replaced.
Reassemble the brake kit according to repair
instructions.
Image 10 Checking worn surfaces on brake block
Image 11 Rotation of bearings in brake block
Play
Make sure that there is no abnormal play in the link bearings. A difference of more than
1.5mm needs to be resolved.
1.0
Image 12 Checking play
1102 086
2018-09-12 15:16
© Indexator AB
17
