Assemble the brake kit
1. Lubricate the inside of the pins, as well
as the inside and outside of the sliding
sleeves with sufficient copper paste.
2. Fit the sliding sleeves inside the pins.
3. Lubricate the centre tube externally with
copper paste.
4. Place a brake disc between the pins in the
lower link, with the locating flat turned
towards the rotator.
Important
Risk of product damage. Do not hit the
centre tube, as this can damage the ball
bearings located in the brake block.
5. Position the centre tube, through the
sliding sleeve in the pin and through the
hole in the brake disc. Ensure that the
centre tube sticks out a few centimetres
on the side where the brake disc surface
is machined.
Important
Risk of reduced performance and product
damage. Incorrect fitting of the brake
block will damage the rotator. Braking
power will be reduced or fail entirely.
6. Place a brake block against the machined
surface of the brake disc. Centre the
brake block hole against the protruding
part of the centre tube. Turn the brake
block's locating flat up against the link.
Important
Risk of product damage. Slightly lift the
brake block before the centre tube has
been inserted, otherwise the brake block
ball bearings will be damaged.
Image 6 Assembling the sliding sleeve
1.
Sliding sleeve
2.
Centre tube
12
© Indexator AB
1102 086
2018-09-12 15:16