Index Everest-D, Service Manual

Page: 20 / 51

Version 2.0
Page 20 Index Braille Printer Company
INDEX EVEREST SERVICE MANUAL
2.4 Hammer configuration
The hammers is working in the following order:
Male hammers (prints page 1, down page in document stack.)
No 1 character
1-3
No 3 character 4-10
No 5 character 11-17
No 7 character 18-24
No 9 character 25-31
No 11 character 32-38
No 13 character 39-42
Female hammers (prints page 2, upper page in document stack.)
No 2 character
1-7
No 4 character 8-14
No 6 character 15-21
No 8 character 22-28
No 10 character 29-35
No 12 character 36-42
2.5 Fault messages.
2.5.1 Failure “100” - No reference-pulse.
Major fault. Turn the printer off/on. If you still get the same message, check the reference-pulse
sensor on the printinghead board and the magnet on the centre plate and the fuses on the
mainboard.
2.5.2 Failure “Front panel open”.
Close the front panel cover and give ON LINE.
2.5.3 Failure “Paper length fault”.
This fault appears when the paper is to short comparing to the measured paper length. If the
paper is dark, for example with a dark picture, this fault can appear. Give ON LINE to continue
printout on the current page. Give REPEAT to continue printing a new copy of the current page
2.5.4 Failure “Paper jam”.
This fault appears when the paper is to long comparing to the measured paper length. Give ON
LINE to continue printing with the current page. Give REPEAT to continue printing a new copy
the next page.
2.5.5 Failure “140”.
Not valid command when selecting A,B or C from computer.
2.5.6 Failure “150”.
Fault in setup file, a non numeric value.
2.5.7 Failure “160”
Major fault. The EEPROM is not receiving or writing information in a correct way.
Try to do a "SUPER-SYSTEM RESET".