FEATURES :
The Testing Pump is very compact, light in weight and can be unbolted to carry easily.
Stand is designed in such a way to keep on plane surface and operate without any foundation. Even
in Testing Pumps also no fixing or foundation is needed. All the working parts are made of Stainless
Steel & Plastic Tank. All the joints are threaded so that any part can be easily replaced even at site
also.
Page # 1- M:231A
TESTING PROCEDURES
Prod.
No.
231A
Memo
Plastic
Tank
Unit Conversion :
1MPa = 10Bar = 10.1972kg/Cm²/ = 145.038Psi
Capacity (Bars)
60Kg./Cm²
Capacity (Mpa)
6
Tank Cap. (Ltrs.)
11
Suction Cap.
23 ML
1.
Usage Instructions
a) Connect pressure hose supplied to pressure outlet. Connect
other end to system to be tested.
b) Pull and push the piston with the handle till pressure gauge
indicating the wanted pressure and then begin testing. If it
exceeds the wanted pressure, adjust the release valve to the
normal condition.
2.
Notes
a) After work, wait until all pressure are relieved, then disconnect
the pump with the tested system.
b) Pump can only used to pump clean water, using it elsewhere
may result in serious accident.
3.
Safety Instructions
a) Do not pump flammable or explosive fluids such as gasoline,
fuel oil, kerosene, etc. Do not use in explosive atmospheres.
b) Check hose for weak or worn condition before each use. Make
certain that all connections are tight and secure.
c) Before servicing, disconnect all power. Ensure all pressure in
the system is relieved. Drain all liquids from the from the system
and flush.
Use only pipe, hose and fittings rated for the maximum (or greater) PSI rating of
the pump.
TESTING PUMP PARTS DIAGRAM
PROD-231A
Page # 2- M:231A
TESTING PUMP PARTS DIAGRAM
PROD-231A
29
25
20
21
19
2
1
9
10
8
11
3
3
3
3
3
3
4
5
6
7
9
18
12
12
12
23
24
13
13
13
14
26
15
16
17
22
27
28
30
31
27
28
27
28
27
28
