Document status
Indel motion boards
11
Document status
Disclaimer
No guarantee is made for the correctness or completeness of the information provided. Subject to technical changes.
File-History
1.15
29.04.2011
Disclaimer
.
AX4: X10 and GinLink pin described; MAX boards: GinLink pin described
1.16
13.05.2011
AX-4: parallel switching of output stages
1.17
17.05.2011
AX-4: Encoder-Stecker für SinCos, Encoder, SSI
1.18
23.05.2011
Missing links to images, address switch Gin-MAX2,4
1.19
07.06.2011
Technical details for connector boards
1.22
30.09.2011
Disclaimer added
1.23
21.11.2011
Correction of +/-5V in Fig. 14: +5V to 32b -5V to 32a
Inc correction to absolute feedback inputs: IncA to Clk, IncB to Data
1.24
31.01.2012
AX4 with resolver option removed, pin assignment for AX4 phase U and V corrected
1.25
21.02.2012
Connection example for 5V/24V single-ended inc encoder
1.26
27.04.2012
Correction: in stand-alone operation of MAX4 and AX4, GinLink Out becomes the ethernet
interface
1.27
27.04.2012
Document status section added
1.28
21.12.2012
Note on RS422 with 120 Ohm completed. The encoder must be able to deal with this load
Ax4 5V supply for encoders from 200mA to 800mA (all encoders together)
1.29
25.06.2013
Expansion of section 3.3.6 Pin assignment for motors in AX4. Connection of stepper motors and
3-phase motors in parallel operation (GIN-Ax4 2x10A)
1.30
26.09.2013
Expansion of section 3.3.6 Pin assignment for motors in AX4 Minimum length for Y cables in
parallel operation
1.31
04.11.2013
Chapter 3.1 add tip for additional cooling measures to keep the ambient temperature below 40°C.
Increase the minimum distance between servo drives to 50mm
Page 54/54
04/11/2013; Rev 1.31
