4
●
Do not use hair-spray while the appliance is switched on.
INSTALLATION:
The wall holder may be installed in one of two ways:
A = for fixed connection lead
B = for mobile connection lead
Attention: before installing the wall holder always switch off the general
switch of your mains electricity.
Each time the appliance is opened, the switch must be used to disconnect the
appliance.
The cable to connect to the power supply must be type H05VV-F 2x1,5 mm².
Method A
1
Unscrew the screw
G
and remove the cover from the wall unit. (fig.1)
2
Mark the fastening holes on the wall. Drill the wall with drill Ø 6. (fig.2)
3A
Break the plastic membrane
D
so that the power supply conductor can pass
through. (fig.3a)
Connect the supply cable to terminal
E
using the cable clamp
F
. (fig.3a)
Insert the dowels and fasten the rear part of the wall support to the wall with
the screws provided. (fig.3a )
4
Apply the wall-support cover and fasten it with screw
G
. (fig.4).
5
Switch the power on at the mains switch. The hair dryer is now ready to use.
Method B
1
Unscrew the screw
G
and remove the cover from the wall unit. (fig.1)
2
Mark the fastening holes on the wall. Drill the wall with drill Ø 6. (fig.2)
3B
Break the plastic membrane
D
. (fig. 3b).
Insert the dowels and fasten the rear part of the wall support to the wall with
the screws provided (fig.3b).
Connect the supply cable to terminal
E
using the cable clamp
F
. (fig.3b)
4
Apply the wall-support cover and fasten it with screw
G
. (fig.4).
5
Switch the power on at the mains switch. The hair dryer is now ready to use.
USE and PRODUCT CARE:
Pushbutton
B
(Fig.0):
ON
=On/Off (pressure must be maintained to operate the hairdryer)
Slide Switch
C
(Fig.0):
Cool
= (low power)
1
= (medium power)
2
= (maximum power)
Summary of Contents for A04520WW
