inbody Yscope, User Manual

Page: 14 / 26

12 13
B. Measuring Posture and Measuring Method
1. Press the button to switch to impedance measurement mode.
2. Wet the side of the subject with an InBody Tissue (or wet tissue) and place the electrode on the measurement area. Push
it so that all the electrodes in the product are attached to the measurement area. All electrodes must be in full contact
with the abdomen to achieve accurate measurements. If the electrode contact is inadequate based on the body type of
the subject, apply diagonal force toward product with the measuring area.
(For accurate measurement, the subject should stand with their arms folded in front of their chest, providing clear
access to the abdomen.)
* Pulling the lever at the rear of the product widens the electrodes.
Pull the lever to make contact between the electrode and the abdomen.
* Please measure with all electrodes of the product in close contact with the
measurement area.
* Pull or loosen the lever to allow the electrode to be attached to the abdomen
and maintain proper pressure until the measurement is complete.
Before pulling the lever After pulling the lever
No Pacemaker No Pacemaker
Measurement area: Sides