inbody BSM270, User Manual

Page: 11 / 64

11
DANGER NOTE CAUTION
참 조 주 의
참 고 주 의
CAUTION
˙
If the rubber finishing material is inserted with the stand, the measured value may be inaccurate.
Be careful when you insert it.
7. Hold the base securely and push the stand into the groove of the base.
Rubber finishing material
8. Insert the base washer into the base screw.
Washer
DANGER
NOTE CAUTION
참 조 주 의
참 고 주 의
ATTENTION
˙
Si le recouvrement de finition de caoutchouc est inséré avec le support, la valeur mesurée
pourrait être inexacte. Soyez prudent lorsque vous l’insérez.
9. Insert the four screws including the washers into the four screw grooves on the back of the base.
10. Using the hex key wrench, turn the base screw clockwise to secure it tightly.
11. After confirming that the base and the stand are fixed securely, erect the fixed base and the stand
to the upright position.
12. Tilt the assembled equipment sideways to align the head bar's groove with the stand, and then tilt the head bar
as shown in the figure. Insert it up to the screw groove while carefully avoiding damage to the switch.