Inbeca MF 22, Operation And Maintenance Manual

Page: 24 / 39

TROUBLESHOOTING
PROBLEM CAUSE MEASURE TO TAKE
Room temperature too high Install unit in a more fresh room
Temperature
Enough or two much quantity Control the refrigerant
Of regriferant
Ice very Water tank level too high Low the tank or the level of water
Ineficient compresor Sustitute the compresor
Axis profile wear away Sustitute the axis
Water doesn’t enter into Tubo de alimentación de agua al
The evaporator evaporador obstruido. Desatascar el
Tubo de alimentación. Limpiar
The unit works
But it doesn’t produce ice Gear teeths of the reductor Substitute the gear teeths
Wear away
Humidity in the system Discharge and charge
Broken water seal substitue
Supply pipe to the evaporator Check the brackets
Damage or free
Lose of water
Float valve doesn’t close Adjust the screw of the float
Joint broken in the outlet Substitute the joint in the outlet
discharge discharge
PROBLEM CAUSE MEASURE TO TAKE
Lime deposit or minerals in the interior Unistall axis and clean it with emeril felt
Of the evaporator or axis Clean the inner surface of the
Evaporator brushing vertically
Aspiration pressure to low Add refrigerant
Water pipe supply to the Check and clean.
Noise and excessive creak Evaporator partially obstruct
Water level tank too low Raise the level
Ball bearing in the evaporator Check and substitue
broken
Ball bearing in the motor Check and substitue
Wear out
Not enough lubricant in the reduction Check lose of lubricant, substitute the
Noisy reduction motor motor Sels and add lubricant
MOBILPREX IP 44
Ball bearing or gear teeth of the Check and substitue
Reduction motor seize up
Inlet water filter obstructed Clean the filter
Nozzle of the water tank obstructed Clean the nozzles after taking out
Lack of water The float
Water supply pipe Check and substitue
From the evaporator partially
obstruct
22