Inateck BS01001, User Manual

Page: 3 / 88

1
English
This is a brief version of BS01001 manual instruction. For more detailed function
illustration, please go to www.inateck.com to download the detailed user manual or
contact us via support@inateck.com. We’ll try our best to help solve your problem in
time.
If you have any problem or suggestion with our product, please contact us via
support@inateck.com.
1. Use of BS01001
How to Charge
The scanner enters low-battery mode after long-beeping for 3 times, which means it
requires charging.
The required voltage for charging the scanner is 5V, and current below 500mA.
Current controller chip is set inside the scanner to filter excessive current - for any
current above 500mA, it filters the excessive current and inputs 500mA for charging.
As long as the charging voltage is at 5V, the scanner should function without issue.
You can charge the scanner with a regular phone charger for the voltage output of a
regular phone charger or a laptop USB port is also 5V.
The charging method of barcode scanner
Charged by the base – Connect the base and a working computer via USB cable, and
the indicator light 1 on the base will turn green. Put the barcode scanner on the base
and then the indicator light 2 will turn red, which means it is being charged. When
the barcode scanner is fully charged, the indicator light 2 on the base goes off.
Charge by the USB cable – Connect the barcode scanner with a working computer,
and the indicator light on the barcode scanner will turn red, which means it is being
charged. When it is fully charged, its indicator light goes off.
How to Start
You can power on the scanner by pushing the scan button. The indicator will flash
green when the scanner is switched on with a beep.
The Use of the Base
The indicator light 1 will turn green when connect the base with a working computer,
which means the base is successfully connected to the computer. The base can
work as a dongle/signal receiver, via which scanning result can be transmitted to a
computer. It can work as a barcode scanner charger as well. Put a barcode scanner on
it, and the indicator light 2 will turn red, which means the scanner is being charged.
The base can be used as a barcode scanner stand. Free your hands by putting a
barcode scanner on the base and setting it to auto-induction mode/Auto Flashing
Mode/Constant Bright Mode. In this case, the barcode scanner is charged when it
works.