Inalto IBM529X, User Manual

Page: 20 / 28

PAGE 20
Care and Maintenance
GENERAL CLEANING
• Dust behind the refrigerator and on the ground
shall be timely cleaned to improve the cooling
effect and energy saving.
• Check the door gasket regularly to make sure
there is no debris. Clean the door gasket with
a soft cloth dampened with soapy water or
diluted detergent.
• The interior of the refrigerator should be
cleaned regularly to avoid odour.
• Please turn off the power before cleaning
the interior, remove all foods, drinks, shelves,
drawers, etc.
• Use a soft cloth or sponge to clean the inside of
the refrigerator, with two tablespoons of baking
soda and a quart of warm water. Then rinse
with water and wipe clean. After cleaning, open
the door and let it dry naturally before turning
on the power.
• For areas that are difficult to clean in the
refrigerator (such as narrow sandwiches,
gaps or corners), it is recommended to wipe
them regularly with a soft rag, soft brush, etc.
and when necessary, combined with some
auxiliary tools (such as thin sticks) to ensure
no contaminants or bacteria accumulation in
these areas.
• Do not use soap, detergent, scrub powder, spray
cleaner, etc., as these may cause odours in the
interior of the refrigerator or contaminated
food.
• Clean the bottle frame, shelves and drawers
with a soft cloth dampened with soapy water
or diluted detergent. Dry with a soft cloth or dry
naturally.
• Wipe the outer surface of the refrigerator
with a soft cloth dampened with soapy water,
detergent, etc., and then wipe dry.
• Do not use hard brushes, clean steel balls,
wire brushes, abrasives (such as toothpaste),
organic solvents (such as alcohol, acetone,
banana oil, etc.), boiling water, acid or alkaline
items, which may damage the fridge surface
and interior. Boiling water and organic solvents
such as benzene may deform or damage plastic
parts.
• Do not rinse directly with water or other liquids
during cleaning to avoid short circuits or affect
electrical insulation after immersion.
WARNING:
Please unplug the unit for defrost and cleaning.
CLEANING THE DOOR TRAYS
• Follow the direction arrows in the figure below:
• Use both hands to squeeze the tray, and with
an upward motion push, you can take it out.
• After the tray has been washed, you can adjust
its position height to your storage requirements.
The image above is for indication only; your unit may
appear differently.
CLEANING THE GLASS SHELVES
• Since the shelves sit in a groove, you must first
lift the shelf up before pulling it outwards.