26
IC-4BRV Hardware Description
5 IC-4BRV HARDWARE DESCRIPTION
The IC-4BRV interface card is designed for the SmartNode 2000 series of devices. It meets IEEE
P1386.1 standards and provides 4 BRI ISDN ports.
5.1 Physical
Specification
•
W / H / D: 149 / 13.5 / 74 mm
•
Weight: 100 g
•
PMC card with 32bit PCI bus
•
CPU Motorola MPC850 @ 50 MHz
•
Memory 8MB SDRAM
•
Power dissipation < 3W
•
Optional internal Line Power Module PM-48V-int (or PM-38V-int): up to 2.5W per BRI port
5.2 Front
Panel
The front view of the ’IC-4BRV’ interface card is depicted in Figure 5-1. The individual sockets are
labeled on the bezel.
Figure 5-1: IC-4BRV Front View
5.3 Ports
The card provides the four BRI ports whose details are tabulated in Table 5-1 below. Each one is
terminated internally at 100 Ohm. See Appendix A for pin out data.
Port
Description
BRI 0
ISDN BRI RJ-45 socket to connect the SmartNode with an ISDN terminal
over an S or S/T interface.
BRI 1
ISDN BRI RJ-45 socket to connect the SmartNode with an ISDN terminal
over an S or S/T interface. BRI 2 may be used as a fallback in conjunction
with BRI 1. See ‘Hardware Bypass’ below.
BRI 2
ISDN BRI RJ-45 socket to connect the SmartNode with an ISDN device over
an S or S/T interface. The pin out and protocol is software configurable. BRI
1 may be used as fallback in conjunction with BRI 2. See ‘Hardware Bypass’
below.
BRI 3
ISDN BRI RJ-45 socket to connect the SmartNode with an ISDN device over
an S or S/T interface. The pin out and protocol mode is software
configurable.
Table 5-1: IC-4BRV Port Description
Hardware Installation Guide, Revision 3.11
Summary of Contents for SmartNode 1000 Series
Page 2: ......
