24
Stretches types:
Short: C1, C3, C4, C5, C6, C7, C9, C10
Long: C2, C8
Long Stretches
Long Injector
Short Injector
Short Stretches
①
②
Replacement of C arms
Please read the following instructions carefully.
Incorrectly tightening or setting the C clamp arms can lead to the arm and clamp overheating and
causing
damage. Damage caused by incorrect assembly are not covered under the warranty
Ⓐ
-
Switch off the machine, or put the machine into
« clamp setting » mode.
-
Unscrew screw (1)
which holds the arm to the clamp.
Leave it on the arm to not lose it
Ⓑ
-
Disconnect the cooling liquid pipes.
-
Unscrew screw (2)
and loosen the lever (3)
on the side
of the clamp.
Ⓒ
-
Remove the clamp arm.
-
Lubricate both a new arm and the support with contact
grease (
ref.050440).
Specific Installation for C2 and C8 arms
For these arms, the Stretches will also need to be changed. Unscrew the short stretches with a flat
spanner and remove the injector. Centre the injector along the axle of the clamp (Caution: beveled side
outside) and insert it manually(1)
Position the long stretches in front and screw it on to the clamp axle (maximum torque 15Nm)
(2).
60
°
!
Summary of Contents for SPOT 14500 TRAFO
Page 4: ...4 Montage ...
Page 27: ...27 Arm types for the C clamp ...
Page 30: ...30 9 CIRCUIT DIAGRAM ...
Page 31: ...31 10 COOLING LIQUID CIRCUIT 11 CLAMP CABLE BEAM CONNECTIONS ...
