CONSTRUCTIONS FEATURES
The machine was designed and built in compliance with the essential health and safety requirements laid down
by the Machinery Directive 89/392 EEC and subsequent amendments.
In particular, given that the operator is in direct contact with the machine :
•
Eliminate sharp edges and sharp angles;
•
Avoid unstable conditions that can result in a risk of overturning, falling or inappropriate movements;
•
Ensure that the operator cannot come into direct contact with live parts during machining which may cause
electric shock or injury.
And everything else needed to secure its use.
The main parts of the
POWERDUCTION
can be
summarized as follows:
1) ON/FF switch
2) Control panel
3) Inductor
4) PCB
5) Fan
6) Cooling unit
Signs and warning signs
On the machine are placed signal warnings and mandatory signs that the operator must follow for his personal
safety and security.
Protections
The machine is safe to use, however the utmost attention is recommended
during use, as heated materials can burn on contact for a long time after the
passing of the inductor. The inductor itself, even if continuously cooled, may
become warm to the touch on parts red-hot and therefore there is a risk of
burns.
The machine is equipped with several electronic protection systems against
electrical surges and overheating. The thermal protection of the inductor
mainly occurs when heating parts in metallic alloys. To start the product
again, release and press again the button. For all the other protections,
switch off the product using the ON/OFF switch.
Finally there are 2x 32 A fuses on the heating circuitry (fuse holder under the metallic cover of the product).
053410_01 01 2015_V1.1
- 4 -