Heating activation
Start the product by pressing the ON/OFF button.
The green LED lights up.
Press the inductor button to activate the heating. Keep
pressing the button to keep the heating active.
The green LED flashes green as long as the heating is
active.
Protections
The product is equipped with protections :
Thermal protection
The orange LED is lit when the product is in thermal protection. The product trigger
is inactive during this time. Wait for the orange LED to go out before restarting the
heating process.
Overcurrent protection
In case of overcurrent, the orange LED flashes. The product trigger becomes inactive.
Restart the product to clear the fault and restart heating.
Trigger defect
On power-up, if the Powerduction detects a fault on the trigger, the orange LED lights
up. Disconnect the faulty trigger and replace it. Then restart the heater.
RECOMMENDATIONS
The coiled inductor is designed for unjamming. it heats metal pieces or parts via induction to unblock and remove them
easily. Circle the piece using the appropriate accessory (coiled, braided, straight), then heat the inductor, that will be
used to heat the metal piece. Once the piece starts to be coloured in red, stop the heating and remove it using the right
tool (clamp, spatter/wrench...) then remove it.
ACCESSORIES
The accessories provided are consumables. These must be replaced when they are damaged.
Afin de pouvoir intervenir sur des pièces à formes multiples, 3 types d’accessoires accompagnent l’inducteur.
3 coiled wire (Ø 18, 24, 30 mm)
Standard tool, already shaped for a fast and effective operation. The coil shape enable optimises the concentration of
the magnetic fields in its centre, which guarantees a powerful and effective induction heating. The glass fiber circle
can electrically insulate the coils as well as the element to heat. The coil is used in the following way : position it at
the centre then press the inductor’s button to start the heating.
Heating efficiency :
To achieve maximum heating power efficiency, the coil must be adapted to the
workpiece.
Flexible braided wire
The braid is designed for pieces that cannot be heated with the coil (parts with a bigger diameter) :
Ex. an exhaust pipe or a wheel hub
The braid can be enrolled around the metal piece.
To obtain a better result, circle 3 times around the metal piece and make sure that the coils are bonded together. Press
the inductor’s button to start the charge.
Straight rigid wire
The straight rigid wire is designed to suit any of the user’s needs. It can be :
- adjusted to the shape of a specific part/piece.
- adjusted to a piece that is too big for the coils.
- copy the shape of an existing coil if the latter is damaged.
12
POWERDUCTION 10R
EN
Translation of the original instructions
