• Equipment in conformity with Moroccan standards.
• The declaration C
م
(CMIM) of conformity is available on our
website (see cover page).
Waste management:
• This product should be disposed of at an appropriate recycling
facility. Do not throw away in a domestic bin.
DESCRIPTION
The Powerduction 10R has been designed to heat ferrous metallic elements by induction heating. Its main purpose is the
unjamming of parts such as bolts or exhaust pipes.
Carry cas econtents:
Le Powerduction 10R is supplied in a carry case that contains t(see fig.1) :
-
the generator and its inductor cable ,
1
,
- 3 coiled wired, diameter 18 mm / 24 mm / 30 mm
2
,
- a flexible braided wire
3
,
- a straight rigid wire 4 .
Fig.1
Coiled wired Ø18 mm
054806
Coiled wired Ø24 mm
054790
Coiled wired Ø30 mm
055469
Flexible braided wire
054813
Straight rigid wire
054868
The elements contained in this carry case are fragile. They’re to be handled with care.
MAINS POWER SUPPLY
This equipment is supplied with a 16 A CEE7/7 type plug and should only be used on an electrical installation
single-phase 230 V (50 - 60 Hz) three-wire with a neutral connected to earth.
STARTING
Assembly
Choose the required tool (one of the 3 coiled wires, the braided wire or the straight wire) and fit it on the inductor. To
do so, insert the two rods of the selected tool and insert them into the holes intended for this purpose, then screw the
tightening wheels (fig.2). To unscrew a tightening wheel, it is possible to use a spanner/wrench size 12. Warning :
never use a spanner/wrench to screw the tightening wheel as it may get damaged.
1
2
3
4
11
POWERDUCTION 10R
EN
Translation of the original instructions
