26
PLASMA CUTTER 85A / 125A
EN
2 - INSTALLATION OF THE AUTOMATIC TORCH CONSUMABLES
Before changing the consumables, cut the power supply using the interrupor behind the machine .
To use the automatic torch, a complete set of consumables must be installed in the correct order: diffuser, electrode, tailpipe, protection shroud and
shield.
Deflector
Protective shroud
Tailpipe
Electrode
Diffuser
Torch
3 - TORCH ALIGNMENT
Fix the auto torch perpendicularly to the part to get a vertical cut.
Use a square rule to align the torch at 90 ° to the metal sheet.
90°
MACHINE OPERATION
1 - PLACE THE EARTH CLAMP ON THE PART TO CUT
Ensure proper electrical contact and do not to put the cable on the cutting trajectory.
Warning:
painting prevents contact between the metal part and the earth clamp, do not forget to sand.
2 - CHECK THE PRESENCE OF ALL THE CONSUMABLES ON THE TORCH (SEE Page 25) AND CONNECT AS FOLLOWS :
Insert the torch’s connector (A) in the female compartment (E) and
screw the B part. Be careful to tighten the torch.
To remove the torch, unscrew in the same manner as above.
3 - START THE MACHINE
and check that no error message is displayed on the screen. In case of error, correct by
referring to the table section «failure Icons». Some errors may require the device to reboot.
