11
Amplifier A Input and Speaker Connections
• Connect the Input signal to amplifier A as
shown in above diagram
• Connect the mono subwoofer as shown in
above diagram
Amplifier A Settings
• Adjust the
LEVEL
control to suit the signal
output from the source.
• Set the Crossover switch selector
(
AMPLIFIER X-OVER
) to the
LOW
position.
Then set the Low Pass Frequency control
LOW PASS
to suit the Subwoofer.
• Select the
STEREO/MONO
switch to
MONO
-24 dB position.
• Set the
SUBSONIC
filter frequency to desired
position (we suggest a 20 to 40 Hz setting)
• You can adjust the bass response setting the
BASS EQ
control.
WARNING
: an increase of 3 dB means the
double of power: use the
BASS EQ
control
with care and moderation since you may cause
damages to the subwoofer (not covered by
warranty).
Amplifier B Input and Speaker Connections
• Connect the
LINE OUT
of Amplifier A to
the
LINE INPUT
of Amplifier B. Be careful to
maintain polarity for correct imaging.
• Connect the front speakers to the speaker
connector terminals as shown on left of
above diagram.
Amplifier B Settings
• Adjust the
LEVEL
control to suit the signal
output from the source.
• Set the Crossover switch selector
(
AMPLIFIER X-OVER)
to the
FULL
position.
