I3H08-12IBD
Specifications / Installation
_______________________________________________________________________________________________________________________________________________
5/12/2010
Page 5 of 5
4
Safety
5
Technical support
Warning: Consult
user documentation.
Warning: Electric
Shock hazard
When found on the product, the following symbols specify:
WARNING – EXPLOSION HAZARD – Substitution of components may impair suitability for Class I, Division 2
AVERTISSEMENT - RISQUE D'EXPLOSION - LA SUBSTITUTION DE COMPOSANTS PEUT RENDRE CE MATERIAL INACCEPTABLE POUR LES EMPLACEMENTS DE
CLASSE 1, DIVISION 2.
WARNING - The USB parts are for operational maintenance only. Do not leave permanently connected unless area is known to be non-hazardous.
WARNING – EXPLOSION HAZARD - BATTERIES MUST ONLY BE CHANGED IN AN AREA KNOWN TO BE NON-HAZARDOUS
AVERTISSEMENT - RISQUE D'EXPLOSION - AFIN D'EVITER TOUT RISQUE D'EXPLOSION, S'ASSURER QUE L'EMPLACEMENT EST DESIGNE NON DANGEREUX
AVANT DE CHANGER LA BATTERIE
WARNING - Battery May Explode If Mistreated. Do Not Recharge, Disassemble or Dispose Of In Fire
WARNING: Only qualified electrical personnel familiar with the construction and operation of this equipment and the hazards involved should install, adjust, operate, or service
this equipment. Read and understand this manual and other applicable manuals in their entirety before proceeding. Failure to observe this precaution could result in severe
bodily injury or loss of life.
For detailed installation and a handy checklist that covers panel box layout requirements and minimum clearances, refer to the hardware manual.
•
All applicable codes and standards need to be followed in the installation of this product.
Adhere to the following safety precautions whenever any type of connection is made to the module.
•
Connect the green safety (earth) ground first before making any other connections.
•
When connecting to electric circuits or pulse-initiating equipment, open their related breakers. Do not make connections to live power lines.
•
Make connections to the module first; then connect to the circuit to be monitored.
•
Route power wires in a safe manner in accordance with good practice and local codes.
•
Wear proper personal protective equipment including safety glasses and insulated gloves when making connections to power circuits.
•
Ensure floor, hands and shoes are dry before making any connection to a power line.
•
Make sure the unit is turned OFF before making connection to terminals. Make sure all circuits are de-energized before making connections.
•
Before each use, inspect all cables for breaks or cracks in the insulation. Replace immediately if defective.
Please contact
For further technical information and a full specification,
please consult the Hardware Manual
IMO Precision Controls Ltd
1000 North Circular Rd, Staples Corner, London. NW2 7JP
Tel: +44 (0) 208 452 6444,
Fax: +44 (0) 208 450 2274,
Web: www.imopc.com
